The Carpet Cleaner
Hiring a carpet cleaner is something that most house owners do about every year to have their carpets deep cleaned. The bulk of carpet manufacturers recommend that you’ve got your carpets cleaned each 12 to eighteen months to keep them in top shape. Daily vacuuming is your strongest defense against dirt buildup and stains as most soiling is loose, but even with steady vacuuming most carpets still need to have the deep-set dirt cleaned out to avoid damage.
There are one or two strategies for deep cleaning a carpet and selecting the right carpet cleaner that specializes in the strategy you need done is your most important step. Many professional cleaners will typically favor either the wet extraction system or the dry extraction strategy and you need to choose which one you want before looking for a carpet cleaner. Both methods are similar in principle but change in what they use for a cleaning agent. Both of them are roughly as effective in the general cleaning of a carpet and do a good job of stain removal. The choice between them is actually a matter of which one your particular carpet manufacturer suggests and your preference. If you do not have the paperwork that came with your carpet when it was installed, you can always visit the carpet manufacturer’s internet site to see the details of their warranty.
The hot water extraction strategy has been used for quite a while and is the most popular kind of commercial carpet cleaning. It relies on specialised appliances that’s used by the carpet cleaner and can either be a self-contained appliance or can just be the nozzle wand assembly that’s connected by a collection of hoses to a van outside of the house that holds the lorry mounted machine equipment. The carpet cleaner will typically pre-treat areas of the carpet that are particularly dirty with a topical pre-spray treatment before beginning to scrub a room to help remove any high-traffic dirt or stains. The carpet cleaner will then use the hot water extraction machine to dry and clean the carpet. The process involves a cleaning solution being dispensed deep into the carpet. This solution is sometimes heated and will right away melt the adhesive bond that holds most mud and grease to the carpet fibers. Shortly after this solution is injected into the carpet, it is removed by an exceedingly forceful vacuum from the carpet to avoid leaving the water in the fibers too long. Even still, the carpet will need four to 6 hours of drying time before you can use the room again. These hot water extraction cleaners are also available in most home improvement stores for rent, and permit the average house owner to wash their carpets themselves. Just be cautious that if you do decide to use one of these cleaners that you aren’t getting the carpet too wet. Make sure you extract as much of the water as possible so you avoid any Problems with mold or mildew forming. If you have any worries about using the cleaner properly, leave this type of deep-carpet cleaning to a pro carpet cleaner.
The dry cleaning technique is equivalent to the wet extraction technique, but is done with a dry agent. This process is relatively new and depends on a chemical property called encapsulation. This property involves a dry cleaning agent that may bind to dirt and grease and dissolve their adhesive bonds, making their removal easy. There are actually 3 different techniques that are typically called dry cleaning and 2 of them actually use a tiny amount of liquid to clean the carpet and are referred to as very low moisture ( VLM ) systems. This first system uses a dry compound to work and needs no liquid at all . This process involves spreading a dry cleaning powder over the carpet and working it into the fibers with a brush. This dry compound will lock onto the dirt and grease and break the adhesive bonds that hold them to the carpet fibers. Once this material has had an opportunity to work, it can be vacuumed up and will carry all the grease and dirt from the carpeting with it.
The last 2 techniques concerned spreading a chemical agent on the carpet and either working it into the fibers with a rotating brush or a device called a bonnet that resembles a floor-waxing machine. Once this cleaning compound has had an opportunity to work, it is vacuumed up and the carpet is ready for use. Both of these strategies work best and are actually VLM systems but leave the carpet dry and ready to use.
Whichever technique you choose, there’ll be a Metro Carpet Cleaner in your area that can help you with the process. Any of these cleaning methods will leave your carpet looking great and extend its life as well.
Rene has been Publishing articles on websites for about 7 years now. Not only does he specialize in a nice range of topics, you can also view his latest posts about serveral carpet cleaning on: Best Carpet Cleaner Machine or Green Machine Carpet Cleaner